LCD displaying issues with the 5LP kit | Cypress Semiconductor
LCD displaying issues with the 5LP kit
So ive been trying to work on getting the kit setup with the CAN/LIN kit and all this time, i couldnt tell if it was working because nothing was showing up on the LCD.
After some research and really looking close at the LCD, i noticed that there was text, but it was really faint and flickering. This was at position (0,0)
So i changed it to use position (1,0) and not you can really make out the text BUT now its like the flickering has slowed down which is allowing you to make out the text.
What can i check to see if i can resolve this? Is the LCD bad? is it just a programming or configuration issue?
The post i found with similar issues was suggesting to revert back to older version of the control, so i went from 2.0 to 1.7 prototype on the LCD.
This is the post i found:
Ive gone thru 1.7, 1.8, 1.9(where im currently at) and you cant see any text when on position (0,0) but you can really see it on position (1,0) but has a slight flicker to it, like someone purposely added that as an effect.
Any help or suggestions would be great.