How to make the psoc5/psoc4 stop running, or start running | Cypress Semiconductor
How to make the psoc5/psoc4 stop running, or start running
During debugging I've set up the breakpoint.
When breakpoint is hit, after 1 sec or so, the chip continue execution, but psoc creator doesn't change the state.
This is the moment when Psoc Creator loose control over the chip forever.
I must connect to the chip again (yellow exclamation mark).
The same aplies to psoc4.
The same situation (brkpt hit) . When I hit continue (F5) software refresh the window, but this doesn't affect the chip.
Chip don't receive run command at all. Even after 100 hits(F5)
The same with PSOC 4.