Error when programming | Cypress

Error when programming

Summary: 1 Reply, Latest post by db123 on 01 Jul 2010 10:01 PM PDT
Verified Answers: 0
Last post
Log in to post new comments.
db123's picture
User
3 posts

I am getting the following error when I try to program my psoc5 first touch board.

 

dbg.M0023: There was an error while programming the device: (PSoC Creator received error (100 - ))

I am able to see the debug target withing Psoc Creator as well as 3.11 Programmer.

I get the same error if I use the programmer directly rather than running through Creator.

db123's picture
User
3 posts

The problem has been figured out. Apparently I have some problem USB ports on my main box.

When I plugged into a powered USB hub, I was able to successfully program the device.

Log in to post new comments.