cannot program in creator 3.3 | Cypress Semiconductor
cannot program in creator 3.3
I seem to have a problem with creator trying to switch to a different device selection when it goes to program my project.
"Unable to acquire target device PSoC 5LP CY8C5888AX*-LP096" was received while trying to change the selected target.
I don't know why it wants to put an * at the end. CY8C5888AXI-LP096 is my selected device.
I have no problem building a project and writing the hex file using programmer, just the program button in creator.
Error: dbg.M0023: There was an error while programming the device: Connection with device lost during programming. Verify the device is connected and try again.
My target hardware is a Freesoc2 board. Any suggestion how to fix this?