Today I make the second Mini Prog3 bad when I was programming process,the VTARG and GND of Mini Prog3 is
Short-circuit. I want to konw why ?
Could you provide us more information about programming setup. What part did you try to program, what borad did you use? Cypress Development kit or custom board ?
ok,Today I use the third MINI PROG 3,and it is also bad.
First ,I use the MINI PROG 3 to programming process(CY21345) ,and it programming process successful, then I use the Bridge Control Panel to debugging,
then I modify the program (to change
CSD2X_1_baBtnFThreshold = 80
CSD2X_1_baBtnFThreshold = 60)after close the Bridge Control Panel;
and ,last I programming process(CY21345) again ,Programming can not be programmed to go a half, this time is when the MINI PROG3 is broken;
I think it is best to raise a case for cypress and give them as much information as possible.
Have you issue a case to Cypress?
Please create a case with the Cypress Technical Support.
You can create a case here https://secure.cypress.com/myaccount/?id=25&createCase=techSupport
I said to Future Electronics (ShangHai) C0.,LTD Branch ,and they say do not know why ,mabye my hand have power or wrong operation or wrong connection ~~~
Do you have any signal that would feed to the programmer, do you use vtag to supply power to some circuits? Do you use the ICE for debugging? You can post you circuit for us to have a look.
Hello, These are some things you might want to try to get the issue resolved:
This is my situation now.
can I have the mini prog3 schematic? I want to modify the mini prog3~~~I think the mini prog3 is not bad very much,becase I give the mini prog3 power the target power LED of the mini prog3 is right,but it always say the target board does not have power~~~~