You are here

Using HCI mode over KitProg USB-UART | Cypress Semiconductor

Using HCI mode over KitProg USB-UART

Summary: 3 Replies, Latest post by Bob Marlowe on 22 Nov 2016 02:57 AM PST
Verified Answers: 1
Last post
Log in to post new comments.
f.honore_1815491's picture
User
3 posts

I'm using the Pioneer 042 BLE board with a long range module (224110). I'd like to use the HCI mode and then connect the UART to the Kitprog so I can communicate over the com port provided over USB.

The problem is that the BLE module enables flow control by default but nowhere to connect those pins from what I can tell.

How do I either:

1. Support flow control over the Kitprog UART and how to connect those pins 

2. Disable flow control in the project for HCI mode.

 

Thanks in advance.

Frank

user_242978793's picture
User
1030 posts

Post you code so we can check it.

f.honore_1815491's picture
User
3 posts

I was just using the example code but the answer is to upgrade the BLE component to 3.2 which adds the feature to disable flow control.

However, now I need to figure out how to get kitprog USB to Uart bridge to look like an HCI device.

Any ideas?

user_1377889's picture
User
9583 posts

Look at the baseboard schematic. The USB-UART bridge just needs an UART on the PSoC and uses the connection to the Kitprog. Check for the required pins.

 

Bob

Log in to post new comments.