You are here

PSOC4 and BLE updates over the air with CYBLE 212019-00 microcontroller. | Cypress Semiconductor

PSOC4 and BLE updates over the air with CYBLE 212019-00 microcontroller.

Summary: 1 Reply, Latest post by Bob Marlowe on 08 Nov 2016 06:53 AM PST
Verified Answers: 0
Last post
Log in to post new comments.
rowland.roderick_1778786's picture
User
10 posts

1/ I am using the Using the CY8CKIT-042 BLE board, with the CYBLE 212019-00 microcontroller.

2/ I’ve created a workspace with :-

The following 2 projects :-

BleFindme01, BLE_OTA_upgradeableStckExample_Launcher01and  BLE_OTA_upgradeableStckExample_Stack01.

 

3/ When I build the project using  PSoc Creator 3.3 ( with service pack 2)  on a laptop using windows 10, there is no problem. I can upgrade over the air with CySmart 1.2 etc.

4/ When I copy the workspace to my PC ( windows 7) & use PSCoc Creator 4.0, the software does advertise & when I connect the Green LED goes off, correctly.

5/ With the Green LED on, I press  SW2, which turn the RED LED on. However, my mobile phone APP sees the over the air update ‘message’,  but CyCSmart does not.

I then press the reset button, the blue led flashes momentarily, the red led comes on .

My mobile phone again sees the update message, but CY Smart does not..

The only way that I can get the microcontroller to advertise ( green LED on) is to reprogram the device through Psoc.

 

6/ The version of CYSmart is 1.2.0.122 on both PSs.

 

7/ Where is the problem ?

user_1377889's picture
User
9606 posts

I would suggest you to get in contact with Cypress directly: At top of this page select "Design support -> Create a Support Case" and ask your question. You will be helped by a Cypress engineer.

Bob

Log in to post new comments.