Measuring current for AN92854 Low power apps TOO MUCH Current | Cypress Semiconductor
Measuring current for AN92854 Low power apps TOO MUCH Current
I am using the BlueTooth Pioneer kit with the PSoC 4 board and using the AN92854 application note. I am running the BLE_CapSense project and not getting anything near the current predicted. I do not have an aperture type DVM. I have a 10Ω resistor across J15 and have a scope and the DVM across it. Both reading mV. The DVM averages the current to board and would represent the load seen by a batter. We have capacitors in the CKT to handle the BLE transmissions but the average current with give us ~ battery life.
With the application running (and seen by CySmart) using 4000 ms advertisements, I see about 9.3 mV across the resistor or 0.93 ma. I can see the advertisement current spikes on the scope But the average current is the problem, it is nowhere close to the < 10 µ amp shown in the appnote.
Is this what I should expect for the average current in this application ? On the scope I see the advertisement for about 6.4 ms spaced at 4 second intervals. I has a peak of about 500 mv or 50 mA.
The hardware we want to build with this, we hope to run from a 2032 cell (240 mAh) for 6 months for a year. Am I totally wrong in measuring it this way ?
Thanks for the help.