My application is optical heart rate monitor. Can I use PRoC4 BLE module instead of PSoC4 BLE module from CY8CKIT 042 BLE kit for this application???
Depends. Does your solution use any components that are not available in the PRoC modules (e.g. UDBs)?
No.. Just port pins only
Well, then just try it. You can easily take your project, set a different target device and compile. The PSoC Creator will tell you whether it works or not.
Is there any output images of optical heart rate monitor using PSoC4 BLE (CY8CKIT-042)?
Am using CY8CKIT 042 BLE. From where i can take VDD_IN and VDD voltages to optical heart rate sensing circuit? and
Is it necessory to give capsense sensors,programming header,power and xres connections?
You do not need to connect signals that are not in use. You may disable compunents that are on your topdesign when you do not need them in the current project and remove (comment) access to the components from your program.
VDD , VDD_IN signals are used in heart rate sensing circuit. So from where I have to give those signals to sensing circuit from PSoC4 BLE??
In the "Quick Start Guide" are all connectors and their signals listed. There you see from where you can pick Vdd and GND. The input VIN is freely selectable but needs to be connected on your topdesign.
Ya.. But there s several vdd connections like vddr,vddd,vdda.. That's why am asked... In baseboard ble_vdd is available.. Shall I use this singal as vdd_in and vdd for my circuit??