WDT Reset at Debugging Mode | Cypress Semiconductor
WDT Reset at Debugging Mode
When I run CE95401(I modified a little) code example in PSoC 4 Pioneer Kit in debugging mode. I put breakpoint to firstline of main. when the device recieves reset , it should return first line again but it doesn't and goes an unknown state . I also put breakpoint to isr_wdt interrupt service routine , it doesnt stop there after recieve wdt reset.
However if I just toggle LED in first line of main and program(not debug) kit works what it is supposed to work
I m asking why the reset doesn't work properly in debugging mode?
I attached my code and Call Stack photo of unknown state
I used PSoC Creator 3.1