vccd pin is connected to 3.3v power instead of gnd | Cypress Semiconductor
vccd pin is connected to 3.3v power instead of gnd
i made a custom pcb using
psoc4 CY8C4245LQI-483 ,
i manufactured 4 PCBs - i am trying to program with miniprog3
in 3 of my custom circuits i get the following error :
" Unable to acquire target device..."
1 of my custom circuits seems to work flawlessly i can program it , debug , control gpio .
after double checking my schematic i saw an error , i accidently routed the VCCD pin to 3.3v instead of
connecting it to gnd (image of how i connected power is attached) ,
do you think this error is a critical design error ??? (i saw some desgins where u can connect it to 1.8v)
do you think this might be the problem ??