unable to programm device after set Debug interface to Gpio | Cypress Semiconductor
unable to programm device after set Debug interface to Gpio
I use the device Cy8C4013LQI.
I must disable all components for power saving.
So I followed the instruction to change the debug interface to from SWD to GPIO.
Programming should always be possible.
But after download the firmware I can not connect the device anymore.
I use Segger-Jlink with the newest Firmware and software.
Here I found a similar problem.
There are speaking about the version p, but in the download area only available version j.
So - how can I fix the problem? Now I blocked 3 prototypes.