PSoC4 thermistor | Cypress Semiconductor
Summary: 4 Replies, Latest post by bobgoar on 09 Oct 2014 03:25 PM PDT
Verified Answers: 0
08 Oct 2014 12:17 PM PDT#1
I am trying to run a pioneer board with the shield adaptor. In running the PSoC4 Thermistor.cdwyn
I get errors when trying to use the Bridge Control Panel. The instructions in AN66477 that you are
to enter :
rx8 [h = 55] @1temp @0temp [t=aa]
in the editor and than click on Repeat.
At this point I get an error message: Script has syntax error! first error (line=1,position =1)
I click on OK
and get the error message: Can't start Repeat mode! It should be a single RX8 command.
I am very new to working with cypress in general and the above hardware/software.
Can anyone explain why I am getting this error, or are the mistakes in the application note Instructins?