I want to use STOP input in PWM mode. Datasheet says that STOP should be available in all modes, but it is not visible.
How can I make use of this input?
In config -
You need to enable the 'stop' input in the configuration dialog of the PWM component (top right).
Dead time is not mandatory to get stop mode functionality.
So I should:
1. Place component in generic TCPWM mode, and enable STOP input
2. Configure component as "PWM with dead-band" at runtime
Please pay attention that I need to stop counter, not just kill output.
As I understand, this configuration will stop timer on kill signal?
I need to use dead time for design reasons, and there is no stop signal input if I enable deadtime.
From the datasheet -
There is some inconsistency in parameter naming, which confused me. Please see picture.
So, STOP and KILL is the same signal, right?
Yes I believe that to be the case.
From Architecture TRM -
Maybe throw together a quick test bed and check. Thats one of the
beauties of PSOC and IDE, quick checks in actual HW easy to do.
I will file a case to get the docs revised.
As Dana wrote: the STOP signal acts as KILL when PWM is configured. Thats why there is no separate KILL signal available.