PSoC4 Pioneer Kit: problem with KitProg | Cypress Semiconductor
PSoC4 Pioneer Kit: problem with KitProg
since around two weeks i have problems with the programmer part of my PSoC4 Pioneer Kit.
When i attach USB to the pioneer the green D10STATUS led is just blinking really fast.
I have read in the pioneer kit documentation at page 100 that this is an indicator that the bootloadable is corrupt. I have uploaded the kitprog.cyacd several times now via the Bootload Host GUI without any error message but it does not work as expected. There is no USB enumeration on windows for the KitProg devices, USB Bridge or anything else. If i am pressing the SW reset switch when the D10 is blinking fast it just restarts into the PSoC5 service mode where i can upload the cyacd-files, i don't have to hold the SW-switch while powering the board.
When i try to use the HSSP example (AN84858) everything is working fine.
I can upload the B_Hssp_Pioneer.cyacd even with my PSoC4 hexfile.c/.h compiled. When i connect to the USB-Serial and press a key, the PSoC4 is programmed correctly.
Can anybody give me a tip what's wrong with the kitprog?