You are here

PSoc 4M CY8CKIT-043 Prototyping Kit Software Example | Cypress Semiconductor

PSoc 4M CY8CKIT-043 Prototyping Kit Software Example

Summary: 3 Replies, Latest post by John Gumaer on 01 Oct 2015 07:31 PM PDT
Verified Answers: 1
Last post
Log in to post new comments.
John Gumaer's picture
2 posts

I am looking for the Breathing LED software example associated with the CY8CKIT-043 Prototyping Kit. The User Guide references code example CE97634 but there doesn't seem to be any code available on the CY8CKIT-043 page, only PDFs for the user manual etc.



user_14586677's picture
7646 posts

Looks like website not up to date on the M series yet.


Consider posting a CASE and request the kit code to install in Creator.


To create a technical or issue case at Cypress -

“Design Support”

“Create a Support Case”


You have to be registered on Cypress web site first.


Regards, Dana.

user_242978793's picture
968 posts

John Here is a program for the Breathing led.  I don't have a CY8CKIT-043 module at this time to debug it to adjust the breathing rates. But this code will work.  I you may need to change the settings in the configure files for the PWM1 and PWM_2 to get you correct led blinking rates. If I had this device I would have adjusted it for you.  I did however set the pin configurations of the design to your -043 device.

John Gumaer's picture
2 posts


Thanks for the code example. I made the following changes and it closely approximates the example pre-loaded on the CY8CKIT-043 module. Here are the changes:

Clock - 32kHz
PWM_1 Settings:
Center Align
Period: 127
CMP Value: 63

PWM_2 Settings:
One Output
Period: 254
CMP: 128

This example was enough to get me going with the kit - thanks again.


Log in to post new comments.