You are here

PSoc 4 Design template missing. Unable to create a PSoc4 design or select the device | Cypress Semiconductor

PSoc 4 Design template missing. Unable to create a PSoc4 design or select the device

Summary: 8 Replies, Latest post by danaaknight on 09 Aug 2015 12:46 PM PDT
Verified Answers: 1
Last post
Log in to post new comments.
dgallatin95_1423736's picture
User
21 posts

Hi, I just got the Pioneer kit and I have downloaded Creator 3.2, but I can't follow the tutorial because Creator doesn't list a Psoc 4 design template
Or for that matter a Psoc 5. It only lists Psoc3 , 4100 and 4200

Am I doing something wrong or is it missing and how do I get the template added?
Thanks

Daryl

user_342122993's picture
User
579 posts

You likely didn't install PioneerKit

http://www.cypress.com/file/46011

dgallatin95_1423736's picture
User
21 posts

I installed the Pioneer Kit
Even says its installed when I check the About information.

The example pioneer kit projects don't load up either when I try opening them up.

user_14586677's picture
User
7646 posts

Something is pretty wacky, the attached is what you should see for templates.

 

Regards, Dana.,

dgallatin95_1423736's picture
User
21 posts

HI Dana, that actually is what I see,but it's not what the tutorials show. They show Empty PSoC 3 Design template, Empty Psoc 4 Design template and Empty Psoc5 temlate

I did finally get that when I uninstalled both the Creator 3.2 adn the kit software and installed

CY8CKIT-042 Kit Setup (Kit Design Files, Creator, Programmer, Documentation, Examples) 592mb
installed. Unfortuntely, this is Creator 3.0 which apparantly has a programming bugwhen I triedprogramming my kit, it wouldn't
The error was PSOC saw the KitPRog device but only listed M0 cortex on the tree and said it wasnt supported

Now I installed 3.2 again. andI have those same choices you show
Which of those is for PSOC 4 pioneer ? The 4100/4200 one template?

NOTE: when I go to Program, it now detects PSOC 4200M CY8C4247AZI-M485 under kitprog

I should also note that my Pioneer kit appears to be different from the pics
I have a round cap sense with arrows , not rectangular
the RGB is below the Arduino headers to the right of the PMOD and I have a header for raspberry PI

Should thier tutorial be updated?

user_14586677's picture
User
7646 posts

Which of those is for PSOC 4 pioneer ? The 4100/4200 one template?

 

Yes, the 4100/4200 template.

 

Regards, Dana.

dgallatin95_1423736's picture
User
21 posts

Hi thanks!
Thats what it is, though in my case its the 4100/4200 M template
There are 2 Pioneer kits(didn't realize that).Apparantly, I have the -44 one
Have run into problem with Control Register API which I will post elsewhere

user_1377889's picture
User
9581 posts

So under the start page of Creator 3.2 ->Examples and Kits -> CY8CKIT-044 -> + you will find a lot of examples for your kit.

Most of them address the hardware on that pioneer board as CapSense and accellerometer.

 

Bob

user_14586677's picture
User
7646 posts

What is the problem with the control register ?

 

Regards, Dana.

Log in to post new comments.