You are here

couldn't debug! | Cypress Semiconductor

couldn't debug!

Summary: 2 Replies, Latest post by waterlaotou on 05 Jun 2012 03:44 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
waterlaotou's picture
User
4 posts

when i clicked the Debug(F5), the debug was interrupted.

and the error as follows: 

Error: dbg.M0015: Debugger exited unexpectedly during run.  Encountered error (Remote communication error: No error.)

Attachments: 
user_1377889's picture
User
10803 posts

There are several reasons:

I had the very same error because my username in windows contained a non-ascii character (use no accents, nothing special, no spaces...)

Some users had troubles with the USB-Cable

Check (double-check) the power-setting of your Miniprog3, setting should be SWD 10pin interface.

 

Bob 

waterlaotou's picture
User
4 posts

thanks for your reply. i debug the example project in PSoC creator 2.0.the attach is the clock configuration.i don't know where the problem is.

Attachments: 
Log in to post new comments.