You are here

"Basic Design" has pft.M0038 x4 and cdf.M0005 x1 errors | Cypress Semiconductor

"Basic Design" has pft.M0038 x4 and cdf.M0005 x1 errors

Summary: 3 Replies, Latest post by Xingwei on 12 Jul 2011 05:14 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
user_101879199's picture
User
37 posts

I was going to use Basic Design to learn about the Debugger. I loaded it and tried to do a build. The errors indicate that the (hardware?) is set to 5.5v on the Vddio0-3 pins (they were so I fixed the jumper pins on the -001 kit board) and I selected 3.3v with the slide switch. HOWEVER, I still get that set of errors when I do a clean and build for Basic Design.

What did I forget or miss?

Thanks

Tim M

user_101879199's picture
User
37 posts

Hi All,

I kept looking.... in BasicDesign.cydwr>pins, found 4 pins showing 5.5v... looked more and found under the system tab that I cound change 'em to 5.0v. Then it built just fine.

Question: if it will not compile (out of range), why set the pins at 5.5v?

Tim

U2
uday's picture
Cypress Employee
569 posts

Hello Tim,

PSoC Datasheet says that VDDD and VDDIO should be less than VDDA. VDDA should always be higher than or equal to that of VDDD and VDDIO. PSoC Creator will generate error message to inform the user that VDDD and VDDIO is out of range. In such case user is supposed to set VDDD and VDDIO to a value less than that on VDDA. 

Please note that this setting is the setting to be made in the project. It is not the jumper setting on your board. VDDA, VDDD and VDDIO voltages can be set under  "project.cydwr --> System --> Voltage Configuration" as shown in picture below.

 

Xingwei's picture
User
1 post
Log in to post new comments.