Unable to receive data from uart on pc using a dma | Cypress Semiconductor
Unable to receive data from uart on pc using a dma
I am comparitively new to PSoC and am doing a small project, "portable oscilloscope" . For this project i am using the CY8C3866axi40 chip es2, development board.
I am using a ADC_DEL_SIgma along with a dma to send data over to the uart. The adc has been set at continuos mode 8 bit resolution mode. The dma source address is "ADC_1_DEC_SAMP_PTR" and the destination adress is "UART_1_TXDATA_PTR".
Whenever i am trying to check the output waveform on MAKERPLOT software, i am getting rubbish data formats or no data at all.