You are here

Tuner Helper connection | Cypress Semiconductor

Tuner Helper connection

Summary: 0 Replies, Latest post by kypparila on 09 May 2014 12:40 PM PDT
Verified Answers: 0
Log in to post new comments.
kypparila's picture
51 posts

I would like to be able to use the 5 pin programmer pins to both program and connect the tuner helper using a miniprog3. So far I have always needed to use a separate I2C port and pins to run the tuner helper. There must be a way to share that connector so that you can both program and then switch right over to the helper. Any suggestions or has anyone done this?

Log in to post new comments.