You are here

Start programm by Switch | Cypress Semiconductor

Start programm by Switch

Summary: 1 Reply, Latest post by Gautam Das on 10 Sep 2011 08:57 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
Minus's picture
1 post

Hello everyone,

I'm an absolute beginner in PSoC Programming and hope someone could help me.

I'm using the PSoC3 on Development Kit, and trying to figure out how I could start the programm with a switch. Normally it starts by supplying.

I want to use both switches, the frist for selecting a special mode. 0 would mean Multiplexer 1 will start, and 1 is for Multiplexer 2. Both are differntial Multiplexers with different "pairs" of signal. After the mode is selected, the second switch should start the programm. It's not neccessary to switch the mode again while the programm is running.

Could anyone help? Or do you have an other solution for this problem?


dasg's picture
Cypress Employee
730 posts

Hi Minus,


By Multiplexer, do you mean Analog Multiplexer component available in PSoC Creator?

Log in to post new comments.