My board does not start when I remove the miniprog3 progamming tool | Cypress Semiconductor
My board does not start when I remove the miniprog3 progamming tool
I am using a CY8C3865PVI_060. It is a small 48 pins PSoC3.
I can program/debug it using the 3 lines /XRES SWDck SWDio and GND.
The board starts only if the miniprog3 is connected to the board (with the USD cable connected to the computer)
The miniprog3 set up is: SWD protocol, external power, reset acquire mode, 10pins connector
When I remove the miniprog3 the board does not start. I have no experience of this small package with optionnal XRES. On the 100pins package, I just remove the tool and the board starts.
thanks for your help.