Miniprog3 5-pin SWD programming error. | Cypress Semiconductor
Miniprog3 5-pin SWD programming error.
I am having an issue with programming using the 5-pin SWD interface. The image and device I am using are both "Production" revision of CY8C3866AXI-040. I am able to program using the 10-pin connector with SWD or JTAG with no problem. But when I use the 5-pin connector with SWD, the software detects the device as "ES1" and the image as "ES3," but both are suppose to be "Production."
Is this a software bug with the PSoC Programmer?
Program Finished at 11:54:33 AM |
| Programming Terminated
WARNING!---> | Debug mode enabled, this should be turned off from PSoC Creator before production.
ERROR!---> | The hex file was built for silicon revision ES3, but the acquired device is revision ES1.
| Use PSoC Creator to generate a hex file for the proper device.
Device set to CY8C3866AXI-040 at 11:54:32 AM | 65536 FLASH bytes
Device Family set to CY8C38xx at 11:54:32 AM |
| Automatically Detected Device: CY8C3866AXI-040