Dose anyone know, how to use P1(SWO) as GPIO with SWD? | Cypress Semiconductor
Dose anyone know, how to use P1(SWO) as GPIO with SWD?
As I know PSoC3 just use 2pins, P1 and P1 with SWD.
So, I disconnect P1 with debugger and disable SWV option.
but It works perfectly with compile and debug.
I'm sure the SWV(P1) does not working now.
so, i was put a rx_pin at P1 and try to compile.
but PSoC Creater shows me below message.
Cannot place "Rx_1(0)" at "[Chip=0][IOP=(1)][IoId=(3)]" because the location is reserved by "SWD debug".
It is connect in hardware?
or just Software problem?
if anyone know, please reply.