hi, I am using a cd pick up head. i want to properly amplify the very small output current of the pick up head using psoc. i used an opamp as a TIA but it did not show any variations in output voltage when a cd was brought neare or taken away from the pick up head. any advice?
Do you have a datasheet of your pickup head?
Can you post your complete project, so that we all can have a look at all of your settings? To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file (do NOT use chrome, that still may not work).
I would start by setting TIA w/ NO capacitive fdbk. Reason
is if you have to take very high G to get a signal, then BW
drops like a rock. Also look into the bit rate you will be getting
off head. This may be beyond the TIA's capability. Further look
at using differential signaling, to get rid of CM pickup in the design.
And / or spend some time making sure power supply noise is
fairly low relative to signal, especially if you are single ended.
How do I know what the recording speed of a CDR or CDRW is?
The speeds are designated by multiple factors.
Example: 1X, 2X, 3X, 4X, 16X, 32X, 64X.
What do these multiple factors mean?
The multiple factor indicates the transfer speed of information between a reading / writing / recording / burning drive to the CDR or CDRW disc.
Multiplied by what?
The base transfer speed used for calculating Total Transfer Speed is 150 kilobytes per second or 150KB/s. Examples:
1X = 150KB/s 4X = 600KB/s
2X = 300KB/s 8X = 1200 KB/s or 1.2MB/s
A lot of CDR designs these days signal condition right at the head,
for obvious reasons.
Thanks for the reply.
I initially used the TIA itself with no feedback cap. due to BW limitations. But it simply failed to produce any observable changes at the output voltage. Is it possible that the current signal from photodiodes of the pick up head is to low to be sensed by the TIA? Moreover, what should be done with reference voltage of TIA?
Did you see the equation in the datasheet
Vout = Vref – Iin × R
Forum SW clobbered input, it is RFB
The reference would set the dark current output from the TIA.
Then depending on the way you wired sensor, sink or source
into the Rfb, the output goes up or down from that point.
Also sets reverse bias on Photodiode.
Yes you could have a photodiode with current so low, nA range, that
there would be neglible output. Or one that is already preconditioned.
Have you set it up on the bench with rev bias, light source and a dark
shutter to check out with DVM ?