Simple Actuator Question | Cypress Semiconductor
Simple Actuator Question
I am trying to use Sense and Control Dashboard 2.0 to have a sensor relay results to an actuator and upon receiving certain results, the actuator performs a task. For example, if the sensor detects a temperature that is too high (say above 30 degrees celsius), the actuator is informed that this condition has been met and proceeds to flash a series of LEDs and start a buzzer.
Currently, I am able to have the sensors results displayed on the Sense and Control Dashboard 2.0. I am also able to set up an actuator that is being sent information based on if the sensor's results meet certain conditions. My problem is How do I have the actuator process information being sent to it and execute a method?
For more details my setup is as follows (all parts are from the PSoC FirstTouch Starter Kit with CyFi Low-Power RF or the Environmental Sensing Kit):
1) Actuator: AAA Battery Pack --- RF Expansion Board --- Multifunction Board
2) Sensor: AAA Battery Pack --- RF Expansion Board --- Weather Station Expansion Board
(I think my problem has to do with relaying information from the RF Expansion Board to the Multifunction Board)
Thanks in advance,