You are here

psoc programmer 3.19 | Cypress Semiconductor

psoc programmer 3.19

Summary: 3 Replies, Latest post by Arvind Krishnan on 06 Nov 2013 12:39 AM PST
Verified Answers: 0
Last post
Log in to post new comments.
sego's picture
43 posts

After few years of programming psoc1 I've downloaded ver.3.19 and latest PD

After regenerating the code, i'm not able to programm the chip.

Below is an error:

Verification of "Protect Area" is FAILED!

I've never seen this message before

What may happened?



user_139039395's picture
107 posts

when I updated the programmer my computer don't recognized my miniprog I solve this problems installing the drivers but if is not your problem, have you tried program another chip? 


user_119377051's picture
866 posts

Hi there

I had saw this message, "protect area..."

It's happen when cable wiring is not good

And take care PSoC's Vdd,

Try reset mode and power cycle mode

And try another USB Hub point where you can connect.

(USB voltage is a bit of different upon every Hub points)

Arvind Krishnan's picture
Cypress Employee
143 posts

It mostly is a problem with the hardware (physical connections from programmer to chip, or problem with the chip itself) than the software. If you're in doubt, can you please try programming with an older version (last good version that you've used) to confirm the issue? Thanks.

Log in to post new comments.