Bridge Control Panel vs Multichart | Cypress Semiconductor
Bridge Control Panel vs Multichart
I am making updates to an older hardware design that uses a CY8C24894 with a UART output. We have 39 total capacitive sensors connected. When you consider the raw value, baseline, and signal for each that comes out to a minimum of 117 different variables we are tracking. For diagnostics, we have a build that will output all 117 variables to the older Multichart program over UART/RS-232 which works great.
When I tried to get the same Cypress software setup with Bridge Control Panel (uses the same packet format), I seem to run into a limit of 32 variables. I have attached my current configuration files to get the first 32 raw values, but I am far short of the full data.
Can Bridge Control Panel handle this much information? Are there any advantages of using Bridge Control Panel over Multichart?
I have always wanted a tool that could show signal values as a bar graph in the X/Y plane with a coordinate overlay (similar to ITO debugger which works for I2C devices).
Thanks in advance,