You are here

UART to Bridge help | Cypress Semiconductor

UART to Bridge help

Summary: 2 Replies, Latest post by bobgoar on 30 Sep 2016 07:40 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
Jeff Jacobson's picture
User
1 post

I am currently working with the UART to bridge example but need help being able to set and clear a pin to control the direction of my RS485 half duplex chip. Its not obvious where the correct place would be to do this. Has anybody done this before? Need to be able to raise the pin and then send out the complete message and then clear the pin.

Maybe there is a better example then the UART to bridge code?

 

Any help would be greatly appreciated. I am using the BLE dongle and pioneer kit with the red module plugged in but I don't think that matters. 

user_242978793's picture
User
1365 posts

Here is some information on this issue.

user_242978793's picture
User
1365 posts

Use UART Version 2.50 component.

Log in to post new comments.