two square waves 90deg using one tcmpw block for stepper motor | Cypress Semiconductor
two square waves 90deg using one tcmpw block for stepper motor
I'm used to msp430 counters with set/reset or toggle settings.
But on proc-ble could this be done using just one tcpmw counter, or is two needed?
Or I should use one timmer-isr? and toggle the pins in software, as a stepper motor rpm is pretty low.
on a PSOC the OV & UN using up/down mode could been routed to flipflops, to create this 90deg signal?
Attached is the picture of counter wise stepping on in1 and in2 (ic is a LB1848MC)