route pwm block to gpio | Cypress Semiconductor
route pwm block to gpio
Hello everyone. I am working on a project with the proc module and I'm trying to generate pwm signals using the 4x PWM block instead of the TCPWM. I read in the Technical Reference Manual that the proc has 4 UDBs and that is where the pwm is implemented. What I cannot figure out is how do you assign the pins where the pwm signal will be outputted.
In the manual it says on Section D: Digital System Universal "Digital Blocks (UDB) chapter on page 133" but there is absolutely no information about the UDB on page 133 or on section D. Is there another document that explains how one routes the signals from the UDB to a gpio?