You are here

Reliable way to count the number of advertisements. | Cypress Semiconductor

Reliable way to count the number of advertisements.

Summary: 1 Reply, Latest post by Madhu Sudhan on 24 Sep 2016 04:31 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
tkosiyat_1665816's picture
19 posts

I current use CYBLE-012011 module. In the GAP Setting -> Advertisement Setting -> Fast Advertising Interval, I set the Minimum to 1000 ms, set Maximum to 1000ms, and Timeout to 6 seconds, and Slow Advertising Interval is unchecked. Is there any reliable way to count the number of advertisements in the firmware since the call to CyBle_GappStartAdvertisement(CYBLE_ADVERTISING_FAST) until timeout (CYBLE_EVT_GAPP_ADVERTISEMENT_START_STOP event was generated with CYBLE_STATE_DISCONNECTED). I use a program to scan for BLE advertisements. Sometimes I got 5 advertisements and sometimes I got 6 advertisements. I tested this in an environment where there is no other bluetooth devices other than this CYBLE module. I would love to have a reliable way to count this in the firmware.

Thanks in advance. I really appreciate for your help.

mady's picture
Cypress Employee
1113 posts


You can include low power mode in your code and then obtain a scope of the device's current supply. You can notice that the current consumption is high during the time of advertisement and low all the times. You can notice 6 peaks.


-Madhu Sudhan

Log in to post new comments.