PRoC BLE Bootloader via UART | Cypress Semiconductor
PRoC BLE Bootloader via UART
I'm working with the PRoC BLE chip called CYBLE-022001-00 and I'm using TI's MSP430 as a host controller which communicates over UART with the CYBLE chip.
Now I would like to update the CYBLE's Firmware with the Bootloader component.
I put up a very simple new Project for the CYBLE module, which only consists of the Bootloader component and a UART Component.
So now, as I understand it, at strart-up the bootloader waits for a defined time for a certain command. If it receives this command, bootloading begins. If not, normal application will start.
My questions are:
- what is the exact command, that it waits for?
- what exactly is the syntax, that I need to use during bootloading? How exactly do I transfer the data?
- Is there any application note on how to program the host-side of bootloading? All I can find are examples where you have to use host application from PSoC Creator, but I need to know how this works in detail.
Thanks a lot in advance and best regards,