MiniProg3 use in Creator | Cypress Semiconductor
MiniProg3 use in Creator
I just got my MiniProg3. I have set Creator MiniProg3 settings to the attached image.
I use the same 4 wire SWD cable setup that I use to program my pcb (with EZ-BLE on it) with BLE Pioneer Kit.
When I connect this SWD cable from my pcb to the MiniProg3 with NO USB cable plugged into MiniProg3, my battery current goes up about from ~2ma to ~3ma.
When I connect this SWD cable from my pcb to the MiniProg3 with the USB cable plugged into MiniProg3, my battery current goes up to ~65ma.
I have never seen battery current above 30ma during the actual programming of the EZ-BLE with the BLE Pioneer Kit and I have not noticed any increase in current when I simply plug my pcb/SWD into a USB attached BLE Pioneer Kit.
I have not left it drawing 65ma for more than a few seconds (only have 40 mah cell) and have not tried to program yet.
Should I continue and try to program or is something fishy in Denmark?