Problem when changing UART baud rate in run time | Cypress Semiconductor
Problem when changing UART baud rate in run time
Hi every body,
I'm doing a project with CY8C24123A, PSoC designer 5.4, using user modules: UART, Counter8 (determine working frequency for UART).
- PSoC receive data from another circuit (P0.4 RX)
-Then, PSoC send data to PC via RS232 circuit (P0.5 TX)
-When receiving data, baud rate is 4800; when sending data, buad rate is 9600
If I don't change baud rate (4800) when PSoC running, PSoC works well (receive or send data OK, I can check data on PC, I'm using Terminal 1.9b).
If I change baud rate when PSoC running, PSoC can't work as I want. No data on the PC! At forum, I knew that I can change UART baud rate in run time of PSoC.
Can you check my project, please? Have you another solutions? Please tell me!