Problem using PSoC5 First touch Starter kit CY8CKIT-014 - Cypress.com Forums http://www.cypress.com/? Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=58442 Get in contact with the technical staff. I'm sure they'd already found a couple of solutions.

Bob

]]>
Thu, 19 Jan 2012 13:12:39 -0600
Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=58440  Exactly the same problem.

Works fine on Win7 notebook and fail under WinXP SP3 on CY8CKIT-050. Both on board debugger and MiniProg3 can't ener in debug mode.

]]>
Thu, 19 Jan 2012 10:58:26 -0600
Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=58002  Thank you Bob and U2, 

I have done a test as you said, but it did not work, I have allready made a case (1094818805), to find the solution to this problem.

Regards.

]]>
Sun, 08 Jan 2012 18:45:30 -0600
Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=57805 I DID file a case already (and it was markes as "solved" for me) but there might be other reasons when this particular error occurs. So if the non-ASCII-character-in-username is not the source of your problem, DO file a technical support case.

Bob

 

]]>
Mon, 02 Jan 2012 04:17:23 -0600
Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=57802 Could you place raise a technical support case with Cypress support, so that it gets more priority and gets resolved sooner.

]]>
Mon, 02 Jan 2012 00:55:10 -0600
Re: Problem using PSoC5 First touch Starter kit CY8CKIT-014 http://www.cypress.com/?rID=57760 I had the same problem. It turned out, that my windows-username contained a non-ASCII character which led to that error.

I created a new user (Named "TestPSoC") and when logged in to that user I could program and debug again. Renaming the non-ASCII username did NOT work!

Happy coding

Bob

 

]]>
Sat, 31 Dec 2011 03:22:32 -0600