Configurable XRES on PSoC 5 - Cypress.com Forums http://www.cypress.com/? Re: Configurable XRES on PSoC 5 http://www.cypress.com/?rID=59632 This feature has been disabled for PSoC5 in PSoC Creator 2.0

]]>
Thu, 23 Feb 2012 03:49:31 -0600
Re: Configurable XRES on PSoC 5 http://www.cypress.com/?rID=59622 The optional XRES input (p1[2]) is no longer supported and has been disabled (it is no longer presented in the System design-wide editor). 

]]>
Thu, 23 Feb 2012 00:38:56 -0600
Re: Configurable XRES on PSoC 5 http://www.cypress.com/?rID=59601 Hi,

I would enalble the optional reset but I can't find that option in the programming\debugging menu.

I use PSoC Creator 2  and I see only two options:

  • Debug Select
  • Enable Device Protection

I use a CY8C5588AXI-060.

]]>
Wed, 22 Feb 2012 08:53:33 -0600
Re: Configurable XRES on PSoC 5 http://www.cypress.com/?rID=51391 Found it.. thanks.

~Abhijit

]]>
Wed, 18 May 2011 01:49:48 -0600
Re: Configurable XRES on PSoC 5 http://www.cypress.com/?rID=51342 Hi Abhijit,

 

Since you are using 100 pin CY8C5588 part, you can enable Optional XRES on P1[2] by selecting the same in the System tab of the .cydwr file.

It can be found at the following location:

.cydwr file > System > Programming / Debugging > Use Optional XRES

 

 

The snap-shot below shows the setting done.

 

 

 

 

Regards,

dasg

]]>
Tue, 17 May 2011 00:35:22 -0600