45W EZ-PD™ CCG3PA USB-C Notebook Power Adapter Solution using MPS | Cypress Semiconductor
45W EZ-PD™ CCG3PA USB-C Notebook Power Adapter Solution using MPS
The CCG3PA 45W Notebook Power Adapter Board is a receptacle based Type-C power adapter. The two major components on the board are Cypress’s EZ-PD CCG3PA (CYPD3174-16SXQ) controller and Monolithic Power System's Fixed Frequency Flyback controller (HFC0500) and Synchronous Rectification Controller (MP6907).
CCG3PA regulates the Type-C VBUS voltage by driving opto-coupler (to primary side controller) using CCG3PA cathode pin using internal feedback amplifier . CCG3PA monitors and handles fault protection like Over-Voltage, Under-Voltage, Over-Current, Short-Circuit and Over-Temperature. CCG3PA drives the external PFET and also controls VBUS discharge with integrated discharge resistors. CYPD3174-16SXQ is factory programmed with DFP CC with Opto Coupler Bootloader, the application firmware for this solution is available in CCGx Power SDK 3.1.0 and any further customization can be done using the EZ-PD™ Configuration utility (refer section 2.1.3 below for more details). CCG3PA CYPD3174-24LQXQ for this solution is available in 16-SOIC package.
Reference Design Features
- Delivers 45W of power to charge USB-PD enabled notebook PC and tablets
- Supports USB Power Delivery 3.0
- Integrates VBUS-to-CC short protection
- Reduces BOM with integrated:
- 30-V Tolerant regulator
- VBUS PFET gate drivers
- Feedback amplifier to directly drive Opto-Coupler
- Low-side current sense amplifier
- ESD on VBUS, CC and DP/DM
Cypress/MPS has developed a reference schematic to enable customer to speed up their design and development cycle time (Board not available for purchase).
For any questions regarding the reference design, please contact Online Tech Support Case System.