Cypress Perform

Application Notes (29)
AN78446 - Interrupt Handling in EZ-USB® FX2LP™ Last Update: 08/02/2013
AN61345 - Implementing an FX2LP™- FPGA Interface Last Update: 18/01/2013
Code/Memory Banking Using EZ-USB® - AN58170 Last Update: 17/01/2013
AN50963 - EZ-USB® FX1™/FX2LP™ Boot Options Last Update: 27/12/2012
AN58009 - Serial (UART) Port Debugging of FX1/FX2LP Firmware Last Update: 26/12/2012
AN70983 - EZ-USB FX2LP™ Bulk Transfer Application in C# Using SuiteUSB C# Library (CyUSB.dll) Last Update: 19/12/2012
AN70486 - EZ-USB® FX2LP™ Host Application in VC++ 2008 Using Suite USB Library (CyUSB.dll) Last Update: 19/12/2012
Interfacing SRAM with FX2LP over GPIF - AN57322 Last Update: 28/11/2012
AN74505 - EZ-USB® FX2LP™ - Developing USB Application on MAC OS X using LIBUSB Last Update: 05/11/2012
AN73609 - EZ-USB® FX2LP™/ FX3™ Developing Bulk-Loop Example on Linux Last Update: 15/10/2012
AN65209 - Getting Started with FX2LP™ Last Update: 15/10/2012
AN61744 - Introduction to CyAPI.lib Based Application Development Using VC++ Last Update: 01/10/2012
AN4078 - Migrating From EZ-USB® FX2™ to EZ-USB FX2LP™ Last Update: 11/09/2012
AN76348 - Migrating from EZ-USB® FX2LP™ Based Design to EZ-USB FX3 Based Design Last Update: 06/09/2012
AN63787 - EZ-USB® FX2LP™ GPIF and Slave FIFO Configuration Examples Using 8-bit Asynchronous Interface Last Update: 28/08/2012
EZ-USB® FX2LPTM/FX2LP18 56-Ball BGA PCB Layout Guidelines Last Update: 22/08/2012
AN15456 - Guide to Successful EZ-USB(R) FX2LP(TM) and EZ-USB FX1(TM) Hardware Design and Debug Last Update: 10/08/2012
AN4067 - Endpoint FIFO Architecture of EZ-USB FX1/FX2LP™ Last Update: 10/08/2012
Configuring a Xilinx Spartan-3E FPGA Over USB Using EZ-USB FX2LP™ - AN63620 Last Update: 24/07/2012
AN4053 - Streaming Data Through Isochronous or Bulk Endpoints on EZ-USB® FX2™ and EZ-USB FX2LP™ Last Update: 24/07/2012
AN6077 - Implementing an 8-Bit Asynchronous Interface with FX2LP™ Last Update: 24/07/2012
Monitoring the EZ-USB FX2LP(TM) VBUS - AN15813 Last Update: 23/07/2012
AN14558 - Implementing a SPI Interface with EZ-USB FX2LP™ Last Update: 23/07/2012
SPI Implementation Using Serial Mode-0 of EZ-USB FX2LP™ - AN67442 Last Update: 23/07/2012
Vendor Command Design Guide for the FX2LP - AN45471 Last Update: 29/05/2012
Interfacing Samsung MuxOneNand to Cypress USB Controllers - AN60081 Last Update: 27/10/2011
AN6076 - Differences Between EZ-USB FX2LP(TM) and MoBL-USB(TM) FX2LP18 Last Update: 17/08/2011
AN15652 - Interfacing a Cypress MoBL-USB(TM) FX2LP18 with an Intel PXA27x Processor Last Update: 22/06/2011
Getting started with AT2LP™ - AN64673 Last Update: 11/03/2011

Product Change Notice (PCN) (7)
PCN125156 Last Update: 18/06/2012
PCN115048 Last Update: 19/04/2011
PCN094816 Last Update: 23/07/2010
PCN050862 Last Update: 18/08/2008
PCN061233 Last Update: 14/08/2008
PCN084676 Last Update: 12/08/2008
PCN071512 Last Update: 17/07/2008

Product Information Notice (PIN) (3)
PCN125157 Last Update: 19/06/2012
PCN104993 Last Update: 19/10/2010
PCN084642 Last Update: 17/07/2008

Device Drivers (1)
My FX2LP development board comes up as a DVB-T product Last Update: 25/06/2011

Device Programming (2)
Instruction for download the firmware using script for FX2LP Last Update: 19/06/2011
Renumeration in firmware for FX1/FX2LP Last Update: 18/06/2011

Documentation (10)
Asserting PKTEND pin when endpoint buffer is full in FX1/FX2/FX2LP Last Update: 19/06/2011
Maximum Input frequency for T0, T1, T2 inputs Last Update: 18/06/2011
eeprom.c and eeprom.h files missing in Vend_Ax example. Last Update: 18/06/2011
GPIF Designer's .GPF files Last Update: 03/04/2011
SDPAUTO (Setup Data Pointer Auto Mode) bit Last Update: 03/04/2011
Disconnecting and reconnecting using DISCON bit in USBCS register of FX1/FX2/FX2LP Last Update: 03/04/2011
Sample code for ECC Check/Correct in FX2LP Last Update: 03/04/2011
Possibility of FX2LP I2C module operation at 400 KHz? Last Update: 03/04/2011
WORDWIDE bit of EPxCFG register Last Update: 03/04/2011
HSNAK bit of EP0CS Last Update: 03/04/2011

Firmware (6)
Error correction in USB data transfer in FX2LP Last Update: 09/12/2011
Setting OUT Endpoint in Auto Mode for FX2LP Last Update: 02/07/2011
Outputting IFCLK in FX1/ FX2 / FX2LP Last Update: 19/06/2011
A51 assembler directive for WORD-ALIGNING the descriptor Last Update: 30/05/2011
Regenerate ezusb.lib with custom changes to source files Last Update: 03/04/2011
What is this error : "Error 22 : NO CODE MEMORY AT ADDRESS 0045H" from Keil Tool while debugging? Last Update: 03/04/2011

General (10)
Knowing data arrival of IN endpoint in the host application for FX1/FX2/FX2LP Last Update: 19/06/2011
FX2LP not functioning properly when using odd numbers of endpoint Last Update: 19/06/2011
SRAM to FX2LP for Memory Expansion Last Update: 19/06/2011
Restrictions/Limitations on using FX2LP IFCLK Last Update: 12/06/2011
Default state of CTL outputs Last Update: 30/05/2011
Eliminating need of EEPROM in FX2/FX2LP Last Update: 30/05/2011
USB-IF Certification for FX2LP compared to FX2 Last Update: 30/05/2011
Differences between FX2 and FX2LP Last Update: 30/05/2011
Possiblity of securing the contents of the EEPROM in FX1/FX2/FX2LP Last Update: 03/04/2011
EPxPING Interrupt in FX2LP Last Update: 28/03/2011

Hardware (4)
Any internal pull up/downs on Port I/O pins Last Update: 30/05/2011
Interfacing other I2C devices apart from boot loading EEPROM Last Update: 30/05/2011
Connecting the metal pad (heat sink) to the Ground Last Update: 03/04/2011
Crystal Requirement for FX2LP Last Update: 03/04/2011

Knowledge Base Articles (17)
GAL code file does not match CY3684 Schematic Last Update: 03/07/2011
Address Valid Time When Using AUTOPTR1/2 for External Data Memory Access Last Update: 03/07/2011
Is there a way to send data over the GPIF interface that is NOT from the USB interface/endpoints? Last Update: 03/07/2011
Minimum Pulse Width for external Interrupt pins INT0# Last Update: 03/07/2011
Device Qualifier Descriptor in dscr.a51 Last Update: 25/06/2011
Crystal specifications of the EZ-USB FX2LP Last Update: 23/06/2011
Steps to Troubleshoot a Customised FX2LP Board Last Update: 19/06/2011
Bulk endpoint buffer size: Setting of SIZE bit in EPxCFG for a bulk endpoint Last Update: 19/06/2011
Ways of configuration of Endpoints 2,4,6 and 8 in FX1/FX2LP Last Update: 18/06/2011
Requirement of Pull-up resistors on SCL and SDA lines when unsed Last Update: 13/06/2011
Using GPIF pins ( RDY / CTL pins) for GPIO functionality in FX1 / FX2 / FX2LP Last Update: 13/06/2011
NextData/ActivateData in the GPIF read Waveform Interval Last Update: 30/05/2011
Schematic Review Checklist for FX2LP Last Update: 30/05/2011
Source code of ezusb.lib for FX1/FX2LP Last Update: 30/05/2011
Enabling External Interrupts in FX2LP Last Update: 04/04/2011
SFR's associated with serial ports in FX2LP Last Update: 04/04/2011
Usage of CPUCS register to reset the 8051 core in FX1/FX2/FX2LP Last Update: 28/03/2011

Software (1)
Creating Script for FX2LP Last Update: 19/06/2011

Specifications (1)
Maximum I/O port pin sink/source current of FX2LP Last Update: 30/05/2011

SuiteUSB.NET (2)
.h file for CyUSB.dll Last Update: 25/06/2011
Setting TimeOut parameter to zero in XferData call Last Update: 19/06/2011

Windows (1)
High bandwidth interrupt transfers (3 packets per microframe) in Windows XP Last Update: 03/04/2011