Cypress Perform

Home > Support & Community
support.cypress.com     Bookmark and Share
Support & Community

Knowledge Base Search



Selected Type:  All Knowledge Base Types

Keyword: Product: Application:  
Results 1 - 25 of 3721 1  2   3   4   5    ...  145   146   147   148   149   Next >
Title Customer Rating Updated
Objects That Can Activate CapSense Sensors - KBA82822 Updated
Question: What materials other than a human finger can activate a CapSense sensor?
Not yet rated 		05/08/13
Extending a CapSense Sensor Above the PCB - KBA82851
Question: Can you extend a CapSense sensor above the PCB using something like a spring or conductive rubber?
Not yet rated 		05/07/13
Configuring Unused Buttons - KBA82818
Question: I have a PCB layout that is used for multiple projects, however, a few CapSense buttons are not used in every project. In these projects, the unused buttons are on the PCB but they are not defined on the overlay artwork. What is the right pin configuration for these buttons in PSoC Designer?
Not yet rated 		05/07/13
Housing CapSense Circuits - KBA82823
Question: Are there any specific design guidelines for housing CapSense circuitry?
Not yet rated 		05/07/13
How to Design with PSoC® 3 and PSoC 5LP - KBA86521
Question: Can you give me a comprehensive list of resources that I can use to design applications using PSoC 3 and PSoC5 LP?
Not yet rated 		05/03/13
How to Avoid the Need for an External EEPROM - KBA83524
Question: Can I use the default VID/PID and default descriptors for the hub to avoid the need for an external EEPROM?
Not yet rated 		05/02/13
How to Configure Unused Downstream Port (D+ and D-) in CY7C65640B/30/20 - KBA83523
Question: How should I configure the unused downstream port (D+ and D-) in CY7C65640B/30/20?
Not yet rated 		05/02/13
Clock and Buffers Programming Kits – KBA87040
Question: Does Cypress offer programming kits for Clocks and Buffers?
Not yet rated 		05/02/13
Difference between FX2LP™ Port I/O, GPIF, and Slave FIFO Modes - KBA83522
Question: What are the key differences between the three modes: Port I/O, GPIF, and FIFO? After I select a mode, can I switch to another?
Not yet rated 		05/02/13
Read and Write to EZ-USB® Internal Memory (AN21xx/FX/FX1/FX2/FX2LP™) - KBA87109
Question: Is there a way to read and write to an EZ-USB memory (AN21xx/FX/FX1/FX2/FX2LP) device?
Not yet rated 		05/02/13
32-bit GPIF Interface failing at 100 MHz - KBA84082
Question: Why does the 32-bit GPIF interface fail at 100 MHz?
Not yet rated 		04/29/13
Maximum I2C Speed at 3.3V - KBA85465
Question: What is the maximum communication speed of an I2C bus at 3.3V? Can I run the I2C at 400 kHz at 3.3V?
Not yet rated 		04/26/13
PSoC® 4 Debug Interface - KBA87096
Question: Which debug interface does PSoC 4 support?
Not yet rated 		04/24/13
PSoC® 4200 System Clock Configuration for 1-MSPS SARADC Sample Rate - KBA87092
Question: How should I configure the PSoC 4200 system clock to get a SARADC sample rate of 1 MSPS?
Not yet rated 		04/24/13
Sink/Source Capability of a PSoC® 4 GPIO - KBA87090
Question: What is the sink/source current capability of a PSoC 4 GPIO?
Not yet rated 		04/24/13
Delay Time Accuracy of PSoC® 4 CyDelay Functions - KBA87094
Question: How accurate is the delay time of CyDelay() and CyDelayUs() with PSoC 4?
Not yet rated 		04/24/13
Interoperating WUSB-NL DVK (CY3668 Rev. **) with nonDVK WUSB-NL Hardware - KBA83288
Question: How do I interoperate WUSB-NL DVK (CY3668 Rev. **) with a WUSB-NL-based nonDVK device?
Not yet rated 		04/18/13
MiniProg3 Board Supply Voltage - KBA87062
Question: Can I attach a MiniProg3 programmer to a target board that will supply 9V on the MiniProg3 VTARG line?
Not yet rated 		04/18/13
Introduction to FRAM - KBA87028
Question: What is FRAM?
Not yet rated 		04/15/13
Binding Composite Devices to CyUSB.sys - KBA84118
Question: Can CyUSB.sys handle composite devices?
Not yet rated 		04/15/13
Converting Error Codes into Strings Using CyAPI.lib - KBA84115
Question: How do I convert error codes (CCyUSBEndPoint::NtStatus) into meaningful strings using CyAPI.lib?
Not yet rated 		04/15/13
Debugging Over JTAG with FX2LP - KBA84114
Question: Does FX2LP support debugging over JTAG?
Not yet rated 		04/15/13
FX3 DVK Power Configurations - KBA83994
Question: Does the FX3 Development Kit (DVK) board support both self-powered and bus-powered configurations?
Not yet rated 		04/15/13
Clock Generation Devices - KBA87039
Question: Does Cypress offer Clock Generation Devices?
Not yet rated 		04/15/13
nvSRAM Definition - KBA87014
Question: What is nvSRAM?
Not yet rated 		04/15/13
Results 1 - 25 of 3721 1  2   3   4   5    ...  145   146   147   148   149   Next >
Sunset Owner: RAIK; Secondary Owner: GRAA;