Cypress Perform

Home > Support & Community
support.cypress.com     Bookmark and Share
Support & Community

Knowledge Base Article



Analog ground not getting connected at output pin.

Last Updated: 06/26/2011

Why can't I get Analog Ground at the output pin even if I configure TestMux for the same, though I get RefHi and RefLo at the output in PSoC1 ?

Only for routing AGND, the respective Analog Block needs to be powered. The block can be power by configuring bits 1 and 0 in ACBxxCR2 resistor. This is not a necessity for routing RefHi and RefLo at the output pin. You can also power the SC Blocks by making the The Analog Power setting as SC On / Ref x in Global Resources. If the power setting is SC Off / Ref x, all SC blocks will be turned off and the ADC will not work.


Related Categories: PSoC® 1


Provide feedback on this article

Did this article help you solve your problem?

Yes

No

Maybe

Additional comments:

To protect your privacy, do not include contact information in your feedback.

Sunset Owner: KXP; Secondary Owner: VWA; Sunset Date: 06/15/20
Spec No: None; Sunset Owner: KXP; Secondary Owner: VWA; Sunset Date: 06/15/20