Cypress Perform

Home > Support & Community
support.cypress.com     Bookmark and Share
Support & Community

Knowledge Base Article



After converting a Toshiba or Morotola based design to a Cypress Neuron my design no longer works what is the problem?

Last Updated: 01/01/2012

After converting a Toshiba or Morotola based design to a Cypress Neuron my design no longer works what is the problem?

There are a number of possible of problems.  It is wise to begin by reading the Application Note  "Designing LonWorks Nodes Using Cypress Neuron Chips" to make sure that all the right steps were taken in the migration process.  If this does not uncover any flaws refer to the document published by Echelon called "Troubleshooting LONWORKS Devices and Twisted Pair Networks" available at http://www.echelon.com/support/documentation/docs/troubl2.pdf.  Also check the the Reset pin and the oscillator behavior.


 


Related Categories: Control Communications


Provide feedback on this article

Did this article help you solve your problem?

Yes

No

Maybe

Additional comments:

To protect your privacy, do not include contact information in your feedback.

Sunset Owner: KXP; Secondary Owner: VWA; Sunset Date: 06/15/20
Spec No: None; Sunset Owner: KXP; Secondary Owner: VWA; Sunset Date: 06/15/20