|
Title
|
Customer Rating
|
Updated
|
AN75511 - PSoC® 3 / PSoC 5LP - Temperature Measurement with a Thermocouple
AN75511 explains the theory of temperature measurement with a thermocouple, and then shows how to do so with a single PSoC® 3 or PSoC 5LP – no need for external ADCs or amplifiers. To make it easy to calculate temperature from the ADC readings, PSoC Creator provides a thermocouple Component. Three example projects are included to demonstrate operation with low and high accuracy and resolution.
|
(5/5) by 1
user
|
05/10/13 |
AN57821 - PSoC® 3, PSoC 4, and PSoC 5LP Mixed Signal Circuit Board Layout Considerations
AN57821 introduces basic PCB layout practices to achieve 12- to 20-bit performance for the PSoC® 3, PSoC 4, and PSoC 5LP family of devices. The design practices covered in this application note are good rules to use in any mixed signal design for any accuracy.
|
(5/5) by 1
user
|
05/09/13 |
AN60590 - PSoC® 3 and PSoC 5LP - Temperature Measurement with a Diode
AN60590 explains the diode-based temperature measurement using PSoC® 3 and PSoC 5LP.
|
(3.3/5) by 3
users
|
05/07/13 |
AN70698 - PSoC® 3 and PSoC 5LP - Temperature Measurement with an RTD
AN70698 explains how to measure temperatures precisely using a four-wire resistance temperature detector (RTD)
|
(5/5) by 2
users
|
04/16/13 |
AN58827 - PSoC® 3 and PSoC 5LP Internal Analog Routing Considerations
AN58827 discusses how internal trace and switch resistance can affect the performance of a design and how these issues can be avoided by understanding a few basic details about the PSoC® 3 and PSoC 5LP internal analog architecture.
|
(4/5) by 3
users
|
04/10/13 |
AN66627 - PSoC® 3 and PSoC 5LP Intelligent Fan Controller
AN66627 describes how to configure PSoC 3 and PSoC 5LP applications to independently control up to 16 fans in a single device.
|
(5/5) by 2
users
|
04/09/13 |
AN58304 - PSoC® 3 and PSoC 5LP – Pin Selection for Analog Designs
AN58304 provides an overview of the analog routing matrix in PSoC® 3 and PSoC 5LP.
|
(4/5) by 4
users
|
04/05/13 |
AN78175 - PSoC® 3 and PSoC 5LP - IEC 60730 Class B Safety Software Library
AN78175 describes the PSoC 3 and PSoC 5LP IEC 60730 Class B Safety Software Library and includes an example project with self-check routines to ensure reliable and safe operation.
|
(5/5) by 1
user
|
03/25/13 |
AN73468 - PSoC® 3 and PSoC 5LP - Single-Cell Lithium-Ion (Li-ion) Battery Charger
AN73468 explains a single-cell Lithium-Ion (Li-ion) battery charger implementation using PSoC 3 or PSoC 5LP. Two types of implementations - linear and switching type are supported. An attached PSoC Creator project, which includes a charge display tool, demonstrates Li-ion battery charging.
|
Not yet rated
|
03/25/13 |
AN60594 - PSoC® 3 and PSoC 5LP: Low Frequency FSK Modulation and Demodulation
AN60594 describes how to create a frequency shift keying (FSK) modulator and demodulator with PSoC® 3 and PSoC 5LP, with digital 0s represented by 2100 Hz, and digital 1s, represented by 1300 Hz.
|
(5/5) by 1
user
|
03/25/13 |
AN73503 - USB HID Bootloader for PSoC® 3 and PSoC 5LP
A complete USB human-interface device (HID) bootloader solution for PSoC 3 and PSoC 5LP is provided in this Application Note. It describes how to add an USB bootloader to a PSoC 3 or PSoC 5LP project. It also discusses how to create your own bootloader GUI using visual C#. The GUI provided uses the HID interface for communication to perform the whole bootload operation.
|
Not yet rated
|
03/05/13 |
AN52705 - PSoC® 3 and PSoC 5LP - Getting Started with DMA
AN52705 provides an introduction to direct memory access (DMA) in PSoC® 3 and PSoC 5LP.
|
(5/5) by 2
users
|
02/18/13 |
AN68403 - PSoC® 3 and PSoC 5LP Analog Signal Chain Calibration
AN68403 explains how to calibrate an analog signal chain by using a calibrated delta sigma ADC and an on-chip EEPROM that is available in PSoC® 3 and PSoC 5LP.
|
Not yet rated
|
02/15/13 |
AN61102 - PSoC® 3 and PSoC 5LP - ADC Data Buffering Using DMA
AN61102 describes how to configure the direct memory access (DMA) to buffer the analog-to-digital converter (ADC) data. It discusses how to overcome some of the limitations of the DMA when buffering the ADC data.
|
(5/5) by 1
user
|
02/06/13 |
AN79973 - PSoC3 and PSoC5 CapSense CSD - IEC 60730 Class B Safety Software Library
Guide to IEC60730 Class B compliance for the CapSense CSD component with PSoC 3 and PSoC 5 microcontrollers
|
(4.9/5) by 36
users
|
01/17/13 |
AN62582 - AM Modulation and Demodulation
AN62582 explains how to implement amplitude modulation (AM) and demodulation using PSoC® 3 and PSoC 5LP.
|
Not yet rated
|
12/12/12 |
AN54439 - PSoC® 3 and PSoC 5LP External Crystal Oscillators
AN54439 describes how to use an external crystal or ceramic resonator at 32.768 kHz or in the 4-25 MHz range in PSoC® 3 or PSoC 5LP. External crystal oscillators provide more accurate clock signals than the oscillators built into PSoC 3 and 5LP.
|
(3.9/5) by 11
users
|
12/05/12 |
AN69133 - PSoC® 3 / PSoC 5LP Easy Waveform Generation with the WaveDAC8 Component
AN69133 describes how the WaveDAC8 component works and how to use it to generate either predefined or custom waveforms.
|
(4.7/5) by 3
users
|
12/05/12 |
AN60580 - SIO Tips and Tricks in PSoC® 3 / PSoC 5LP
AN60580 explains the following applications of SIO pins: Comparator, Charge pump, Level shifter, Half wave rectifier, Peak detector, and Sleep wakeup using SIO Comparator.
|
(3.5/5) by 2
users
|
12/05/12 |
AN52927 - PSoC® 3 and PSoC 5LP - Segment LCD Direct Drive
Although segment LCD modules are available with inbuilt drivers, these modules are more expensive than segment LCD glass. PSoC® 3 and PSoC 5 LP, with its configurable analog and digital hardware, also has an integrated configurable LCD driver that supports a wide variety of LCD glass types. This application note explains how to drive multiplexed segment LCD glass using PSoC 3 and PSoC 5LP.
|
(5/5) by 1
user
|
12/05/12 |
AN66444 - PSoC® 3 and PSoC 5LP Correlated Double Sampling to Reduce Offset, Drift, and Low Frequency Noise
AN66444 describes the implementation of correlated double sampling (CDS) in PSoC ® 3 and PSoC 5LP, for DC offset cancellation and noise reduction.
|
(2/5) by 1
user
|
12/05/12 |
AN62510 - Implementing State Machines with PSoC® 3 / PSoC 5LP
The method to implement state machines using the PSoC® 3 / PSoC 5LP family of devices is explained in this Application Note. Mealy and Moore state machines implementations are shown with associated projects.
|
(4/5) by 1
user
|
12/05/12 |