Hi

I'm having a problem  with building my project. Have the following error code

The command 'arm-none-eabi-gcc.exe' failed with exit code '1'.

Hi Maduna,

Right click near the menu bars and enable the "Build Configuration/Toolchain".

Let us know if this helps.

If you upload the project, we can test if there is any specific issue causing this error.

 did you get any error or warning on the output section while building the project?  You can upload the project for people here to check.

This error-message is, afaik, the last message in a row, saying that the compilation was aborted due to one or more compilation error(s). Check messages before (above) this one.

Hope it helps

Bob 

The Build Configuration/Toolchain did not yeild any positive response.

I did not get any other error from teh screen after the build. I only obtained the

 Error code  'arm-none-eabi-gcc.exe' failed with exit code '1'.

let me upload the zipped program and check it for me on your side and i'll give a bried xplanation of what im trying to read out

Yes,go on and upload. We'll have a look at it.

Bob

I'm having a problem uploading my zipped code. it goes on forever . any tip

What is the maximum size i can upload? I have compressed it to 3.25MB

Hi Maduna,

Please use "Minimal Archive" to archive the project.

Following is the procedure:

1) Right click on the Workspace and select "Archive Workspace/Project"

2) In the Archiver window, select "Minimal". 

In this method, the Creator generated files will not archived thereby reducing the file size.

and make a "Clear" before, it reduces the size as well.

Bob

Its still failing to load. i'll keep trying....

I'd suggest that DASG or someone gives me their email and i send it to them and tehy can upload the the project because i have been trying to do this for about 4hours and i'm failing. Is that ok

Bob or DASG could you send me an email on madunaski@yahoo.com then i can send it through to you because i'm still failing to upload the file. I have reduced it to 600Kb but still failing to upload. Then you can upload it from your side.

Hi Malvin,

when I compile your project (Creator 2.0), I get

7 Errors,

9 Warnings and

2 Notes.

On the very bottom line (maybe hidden by the task-list at your desktop?) on the right-hand corner are the counts listed for errors, warning and notes. When you click at one of them, the window changes from "output" to "Notice" and you can see all your errors.

You may click as well to one of the tabs of the notice-window to hide or show the errors, notes or warnings. Since you did not see any of those (only in the output-window the error-message of the failed compile) I suppose that it is hidden from your sight by the task-bar or something similar.

Search for the bottom-line of the >Creator-Window.

Bob

The project which Maduna is referring to is attached along with this comment.

I have managed to solve teh issues i had. Its running well now. Thanks for the efforts.

You are welcome!

Bob

Hey Maduna,

Good to hear that!

Was the error you were getting initially due to improper initialization of the variables using "extern"?

Yes DASg, teh error was due to the initialisation of the 'extern' keyword. And teh error comes as

 'arm-none-eabi-gcc.exe' failed with exit code '1'.

with no reference. That is what was making it dificult but i had to go through the whole program and initialied the extern kewyword in main.c instead of the RGBSensor.c file. Much appreciated.

You can view the errors, notes and warnings by selecting the "Notice List" tab.

It gives a list of all the errors and warnings. The snapshot below shows the notice list of the project uploaded.