![]() |
ANCY |
|
|||||
I am getting the following error when I try to program my psoc5 first touch board.
dbg.M0023: There was an error while programming the device: (PSoC Creator received error (100 - )) I am able to see the debug target withing Psoc Creator as well as 3.11 Programmer. I get the same error if I use the programmer directly rather than running through Creator. |
|||||
|
||||||
|
The problem has been figured out. Apparently I have some problem USB ports on my main box. When I plugged into a powered USB hub, I was able to successfully program the device. |
||||||
Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Terms and Conditions of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms and Conditions of this site. Cypress Semiconductor and its suppliers reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.