For testing programming, on my new PSOC5 module(CY8CKIT-010) for the DVK1 development kit (CY8CKIT-001), I tried to use the 3.12 version of PSOC Programmer with the MiniProg3 to load in the CY8C55_QSG_Startup.hex. This file is located in the Firmware folder on the CD for the PSOC5 CY8CKIT-010
When I try to Verify or Load the hex file I receive the following error...
FAILED! Can not Load Hex File. File does not exist or it is corrupted!
I have tripple checked the settings for Programming mode, Verification, Autodetection, Connector & Speed... And they all look correct. I have copied the file to my local hard disk, tried different directory names, file names, etc.
Additionally loading the CY8C38_QSG_Startup.hex on my PSOC3 modules works perfectly.
Any help would be wonderful as I am a bit timid in working on a large design for my PSOC5, for it to not program. I know this sounds silly, but I also like to load the Startup hex onto my PSOC devices when I am done for the night as it assures me that I have not killed anything :)
Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Terms and Conditions of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms and Conditions of this site. Cypress Semiconductor and its suppliers reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.