The FX3 is new for me, and I find it difficult to information about how to configure the IO matrix.

If i set 1 bit in "io_cfg.gpioComplexEn[1]" or "io_cfg.gpioSimpleEn[1]", my application don't start.

My need : 

GPIF:

    GPIF IO[0..7]                 (8 bit GPIF data bus)

    PCLK (GPIO[16])         (Clock for GPIF)

    GPIO[28] & GPIO[29]  (Input for GPIF)

SPI:

    SPI_SCK (GPIO[53])

    SPI_SSN (GPIO[54])

    SPI_MISO (GPIO[55])

    SPI_MOSI (GPIO[56])

UART:

    UART_TX (GPIO[48])

    UART_RX (GPIO[49])

GPIO:

    GPIO[22]  (Output)

    GPIO[34]  (Output)

    GPIO[36]  (Output)

    GPIO[37]  (Input)

    GPIO[38]  (Input)

    GPIO[39]  (Input)

    GPIO[40]  (Output)

    GPIO[41]  (Output)

    GPIO[46]  (Output)

Poul-Erik.

Hi,

while configuring the IO-matrix you have to take care that the pins which are used by UART, SPI and GPIF can't be used as simple or complex GPIO anymore. In gpioComplexEn[1] and/or gpioSimple[1] you can enable the pins [32...63] for GPIO-usage BUT they must not be already occupied by UART, SPI or GPIF!

Best regards!

With this configuration where will my UART be connected ?

    io_cfg.isDQ32Bit = CyFalse;
    io_cfg.useUart   = CyTrue;
    io_cfg.useI2C    = CyTrue;
    io_cfg.useI2S    = CyFalse;
    io_cfg.useSpi    = CyTrue;
    /* This mode is for SPI, UART and I2S. I2C is still enabled. */
     io_cfg.lppMode   = CY_U3P_IO_MATRIX_LPP_DEFAULT;
    /* No GPIOs are enabled. */
    io_cfg.gpioSimpleEn[0]  = 0;
    io_cfg.gpioSimpleEn[1]  = 0;
    io_cfg.gpioComplexEn[0] = 0;
    io_cfg.gpioComplexEn[1] = 0; //!

    status = CyU3PDeviceConfigureIOMatrix (&io_cfg);
 

I can't get any debug out.

This you can easily find out with the pin-description in the CYUSB3014-manual!

UART will be at pins GPIO[46...49], SPI at GPIO[53...56], I2C at GPIO[58...59].

Regards!

Hi Paul-Erik,

you get the UART at the GPIO pins 46-49

refer to datasheet of the FX3 Document Number 52136 on page 33 "Pin Description". If GPIF II is configured to 32-bit data mode, then UART is configured to the GPIO pins 53-56.

Regards,

lumpi

Thank you for your input.

I found an error in my PCB, (RX and TX was swaped), and after than i works.

Poul-Erik.