Hello,

There are several calls of the CyU3PDebugPrint() function used in the SDK examples. With this function calls debug messages should be transmitted via UART/RS232. Is that correct?

My Com Port setting are the same then in the expamples:

    uartConfig.baudRate = CY_U3P_UART_BAUDRATE_115200;
    uartConfig.stopBit = CY_U3P_UART_ONE_STOP_BIT;
    uartConfig.parity = CY_U3P_UART_NO_PARITY;

To make sure Debug Messages are sent I added a CyU3PDebugPrint() call in the for (;;) loop of the BulkLpAppThread_Entry() function of the USBBulkLoopManualInOut example. The priority level is also set correctly.

My problem is that I do not receive any debug message at the PC. I even could not measure anything at the UART Pins.

I work with the FX3 DVK Device Board.

How could this problem be solved?

Thanks and best regards

 Hi,

Please try the steps in the following post :-

http://www.cypress.com/?app=forum&id=167&rID=51400

Rgds,

M

Ok. Thanks. This works.